Search results

When you plug the receiver into the Flight controller you get 5v. The FC gets it from either the BEC or ESC depending if your ESC has it built in.

i knew you were from somewhere in Ohio. Athens is not too far from here; you were closer than I thought.

I typed the last message up almost an hour ago, and forgot to hit submit :).

Here is a mod that I'd suggest.

I was experimenting with a method to paint my quadcopter frame The method I just used on some of my parts is commonly used to get patterns on guitars. Fill a container that is large(r) enough to hold the item you are dipping with water put oil paint on top in a thin design if you are using...

If you have a flash tool, you should probably flash it with stevis firmware. Are you enabling auto level, to do s oyou have to move the right stick to the right wile arming or disarming. Where it says auto level: off it should turn to on. I like to enable it by disarming while it is already...

Anyone near Portsmouth, Ohio (far-far south in Ohio touching Kentucky)? a friend of mine described a phantom looking quad flying around where I like to fly.

haha, I have yet to become competent in flying. So less sensitive the better for me :P

Sweet, I am considering on buying more parts to make a 6Y, as it has minimal redundancy, and is fairly cheap. I think before try to get a LRS setup I will do this, to avoid going down with no control. :) A couple people on facebook got me interested in the 6Y design, no you have me really...

Haha TVs and laptops listed?

I saw this in another group and found it to be extremely funny. Anyone going to do this next time you fly FPV in a group?

I don't know any thing about the condition, nor did I read, but I saw this today if you would like a Phantom one (Used, I think)

Yeah, Charpu has some really cool videos. He buys props a little big and curs them down to make his quad faster. He has a few videos, each one is really good. It made me wish I had built a 250mm instead of a 370mm quadcopter :). I should have went to a 450, as I would be able to lift more...

Not really, the KK is very limited, it is just easy to setup. I'd stick with the one you have. TAke a look at this; it is a list of flight controllers. The KK is marked KK muticopter

I don't know on that. :P You may be able to if they have the same microcontroller. Or if their higher level interface uses the same language/engine.

I saw this on face book, and now I just have to wait until I get to upgrade to this. :P

Haha, I had seen this. I think he just used a starwars collectable and turned it into a hex. Looks really good too.

What do you plan on using the quadcopter for. You will probably want FPV (First Person View flight); am I correct? First you need to decide your budget. What you plan to use it for, basically just so you know how much you will need to lift. Decide what flight controller fits your needs...

DJI uses mostly the Naza flight controller. If by Pixhawk flight controller then yes. As long as you have all of your motors the same, and your ESCs the same as each other (big enough for the motors), then you can basically mix and match any brand parts.

Two motors have to spin CW with CW props on them, and two motors have to spin CCW with CCW props on them. If you have lets say you have a motor spinning CW and you put a CCW prop on it, you will get downward thrust as apposed to upward thrust. The bolt thread is usually the same direction on...