Search results

3.4 is a little low, you may have a bad battery, have you ever ran it too low or too hard?

What took these pictures haha

The well it would take very little time to hook a rx up to the quantum v2 googles and the camera set is plug and play.

That is interesting, are you flying until the battery dies, or letting them cool? Heat and impact appeares to be the biggest enemy to coreless motors.

Is there some sort of insulator that goes over that, like maybe liquid electrical tape of hot glue? Building and testing? I need a new job haha.

It is IR, so are you getting about 20' range?

Don't get the teleporters, I have known people to throw them away out of the box haha. Their picture is the size of a postage stamp (if that) and you can't make out much of what is in front of you. If you want fatsharks then I'd get at least the Domv2. If those are out of your budget then...

You want to re update it to 1.8S1 the 1.9 is for quads with sensor problems. Can you upload a short video of the problem? I still think it is a problem with Pgain, but the video should tell. Try it with self-level on, and then with it off.

Are your motors 2312kv? With 9'' props then there is wonder they burnt around 1200 kv motors are suitable for 9'', 3212 would be more for 5''. How fast were they trying to spin while in contact with the ground, it would burn the motor up if they were trying to spin but were stuck.

Probably not motor ware unless they are stiff BEFORE you plug the battery in, be careful not to mistake FET drag for dirty motors (if they are DC motors (two wires) FET drag is not existent). It is probably a battery problem as that is very common, running the batteries low and charging them...

if only in Self-leveling mode then: • P Gain – The power of the self-levelling. Higher number is stronger. Too high will cause oscillations. To low and it’s slow to self level. Higher number gives the operator more stick control. Lower number reduces the operator stick control. • P limit –...

Slow or fast wobble, it has to do with the gain in autolevel. You can turn self-leveling off and fly like that and you won't have to worry about adjusting it, but it is easy to adjust. http://www.hobbyking.com/hobbyking/store/uploads/1009997851X1124309X6.pdf

Yeah, just make sure it is the correct cable, if you have two disconnected (one hot one ground) and switched the two it could fry it when the switch gets flipped. If only one broke wire then it should be fine to connect.

My largest in size is a 700mm, my largest in weight is about 3.5 pounds haha. I am looking into different motor layouts to try to get something new.

Hahaha.

The good news is that about anything is fixable on them. You need to open it up and look for a broken wire or broken solder joint, it sounds like it is the main power, so if you have it try using a continuity tester. to see if traces are broken, if you find a broken solder joint on the PCB you...

I just looked at some of the add-ons and found country flags. https://xenforo.com/community/threads/country-flags.32845/ This could be helpful: https://xenforo.com/community/resources/best-answer-q-a-system.4288/

I think that there is already a mod made for xenforo forum software that will do that, but as it stands members can do it voluntarily.

If you don't know then take the props off, arm the FCB, and put the motors at about 30% and then turn the controller off. If it shuts off then it does, if not..... Then you would loose your quad in the event of lost signal.

Haha, your living the life, I'd love to go hang gliding or sky diving, but I'd have to spend 1000 in gas just to get somewhere I could xD Not counting the actual cost haha.