Search results

Ha I thought you on about big models or something. So he gets funding then sells em. Now that's capitalism

I've never seen any of the above windows before. I did change the version CH-15 But my cheap esc's where not in the list so I couldn't find which one.. I binned them and learned a lesson I've never repeated.

Yes cowboy it's ibus ready but only if you get the 10 channel firmware update. In which case you have to buy a cable. So as is, its only pwm or ppm.

Hook line and sinker. :p Again. I didn't mention the moon.

No consistent pictures of the moon ever. Not one full frame shot except through a window with a circle cut out. Even nasa says "its photo shopped it just has to be". Thousands of satellites up there and not one full frame shot from any of them. 50million a day o_O on what.

First on whato_O I'm not going through this again:p I looked into Tor pressure and science says they didn't go. To the moon:eek:. Low earth orbit is about it. They didn't get through all that radiation in a box of tin foil. And all the evidence that says otherwise. Kubrick admitted so. Unless...

You didn't say about solder joints. I was just saying the boards do get hot so get them up ASAP. You seem pretty knowledgeable so I'm done here.

Higher kv usually means less power .i got racerstar 3800kv 3S The 6000kv marked as 2S. But i do run 4S on supposedly 3S.

I got me a led data cable. No mistakes like that. It just goes out your head.

It's the stupidly basic one you always forget. Doh.

Simonk are just basically calibrate only esc's. I'd say go with these as no acro involved. Not sure but you may still be able to use blheli esc's with APM just not configure them in like in passthrough as normal. Simonk run wing models better than blheli do with lower kv motors. They just could...

R. I. P. Little flight controller. Yes them little boards do get hot very quick. I get mine in the air asap. And I'm sure the 6k kv are 2S only. This shouldn't effect the board though. I read recently that some 4in1 esc's are being sent out with the wrong esc-fcb jst cable. And the wire 's need...

I not find either. Any link for it OP.

Some of the newer boards need this or zadig to kick it off.

Sorry this one

Do you have zadig or RC driver installer. Run one of these or have it open when you do it.

o_O

Ia6b is either pwm ppm or if you took the 10 channel upgrade for the tx you can use ibus.. But need to apply serial rx in config tab in betaflight.

In firmware flasher match your baud rate. Turn on no reboot sequence Turn on full chip erase. Short the boot pins. Flash on connect Then apply power. It should kick in. You can't brick it so no worries.

Unless somthing shorted the motor should be fine. Its hard to kill a motor through esc. Maybe if the motor wires shorted while applying throttle, say you partially ripped it off and the solder joints touch. that would do it. Motors can run in water due to the windings being coated. Dont quote me...