Search results

You will have to download the standalone from github. Extract the zip file then save to driveC

Will ardupilot work on a SPRF3 I just googled compatible boards & it wasn't in the list.

Go fly have fun. :D

You will notice there is more than 2 pins on the port with the ground being the outside. These cables are peanuts on ebay. The calibration screen came up and you just moved the corresponding stick to the outer edge in all directions. Click finish, done. I think the one above is a trainer...

With my i6 & evo. There was just a calibration page on the freerider game. Basically plug & play. And there was 2 types of cables. You may have the wrong one or set yours up on the wrong pins on the port.

I may try ardupilot if inav no work before I have a go on Betaflight.

Trying to accomplish just keeping it up. Hardly any Surface movement in angle or horizon Not enough to counteract anyway. Full throttle & full back on pitch & it just bombs. CG is on the line & it's below the expected weight, especially after it being reworked last night. Nav launch failed &...

Finally got out today & it's not good. Its intact its working just some loose stuff after about 20 failed throws. I am not having a good experience with iNav. Many problems like nav launch not kicking in, even though the commands to get out of it work. Hardly any surface movement in modes...

Pal gives a better picture. And that list is OK but that's some power for a newb. Have you got a few hours in with other quads or is it literally your first. If so you might want to pipe it down a bit & start with a 4S. Even ppl who fly 5S+ have problems taming them. They need proper pid...

Well now that you have one, look at it as insurance so you can prove you have done nothing wrong. So don't do any wrong & walk righteous.

Betaflight 3.4.0 F4 osd micro 20x20 Are decent boards can run all the gear with no need for pdb if using a VTX03. Or any 5v vtx. & depending if your esc can take 4S so can it. I don't rate the piko. Next micro I buy will be a matek F411 mini. I just got an F411-WING & layout is good. Its been...

Err no thanks err I'll have a sip of water.

Sounds good until yo get to the coordinates & some homies show up.

He wants to put some of that on his cooker, o_O eww :confused:

Threaten it with a soldering iron. Only hold it like your going to stab someone though. :mad: works for me. Dji should rename themselves to Jpi Just Post It.

silky smooth pineapple action. :D

In the modes tab, does the slider move into the range for arming. If you reversed a channel, did you do it on the tx. My arm is on SWD which is a 2 position switch on channel 5. Just move the sliders in arm tab so the range is covering the right side half. Or you could make it tight on it. But...

It's sea water that's the killer. You have to be quick. You can wash what you want with no effect. But you need to dry it out thoroughly. The only thing with the liquid silicone is, it stinks & its there forever mixed in with the Solder if you replace parts. It gives a seal on contact & dries...

New RC rules coming to UK Registration & a lift on on the height to 1000ft. But not drones or aircraft with stability or safety features. But other stuff along with it gives police sweeping powers to confiscate & search your home. You couldnt make it up.

It would work for a line of sight quad with just an rx. Or a bigger build with a pdb it should be fine as it is, its a lame duck for a small micro.