Search results

Not for a dud lipo. Only solution is a new one. Maybe if you had a power adapter with different voltage settings 5v 7v 12v. You could jury rig an adapter to power the quad. You not get far lol but you would know for sure its the battery.. Its the battery anyway going from the explanation.

Sounds like he's waiting on a new lipo.

What did you do,checking the voltage wont make it work. What was the outcome. & how much was this f105.

He private messaged me I told him to open a thread, I said also to check battery voltage after charge & the time it dies. Should get at least 5min. & try not to run them right down below 3.6v as this is no good for the cells.

The flight controller does not beep. it is the motors that beep. Go back through the steps I mentioned above. If you can see the esc in blheli then it's OK. You may just have to set both endpoints & then do the same in the configuration tab in betaflight but make sure they match. The only...

My IPD is 72mm, I can't get any to fit. Some goggles are not as advertised sizes So I'm stuck with my quanums. :( But my groundstation rocks so it makes up

I'm using simonk, old but they work.

What endpoints you have in the configuration tab should match what is in blheli. That motor 2 values may be different Or you have a bad connection Dry Solder joint.

You got a picture battery goes to its own pads, esc go to there own += Esc signal wires to motor ports 1-4 Rx to a uart. To calibrate the esc you have to check the box, move the slider up, then plug the battery in, wait for the beeps to finish. Then move the master slider back down. Wait for...

Bad pid setting cause oscillation or shaking. Higher C rating does give more bite. I can tell & feel the difference on a turnigy 20C to a 40-75C. Like Renov8r say not really needed but will provide extra power if needed. I only use 3S now for groundstation equipment

Turnigy or turnigy nano & tattu is all I buy.

Acro flying 40C or higher. I got a few 20C I use for milling about.

Welcome :cool:

Move to betaflight ,its a lot better for quads. Just fir the osd alone is worth it.

No Osd on the flight controller?

Oh the jo_Oy.. I just manually calibrated 15 esc's & found 3 duds. The original I opened fresh, one I must have thought I did & then other 13 the second & to last was a dud. Suppose after using about 60 of these & having 7 duds is not bad. So now just the servo problem. Betaflight Seems to get...

Supply it 5v & just put th signal & ground on. Plug the lipo into the quad.