mavic pro crash ,motor or esc to blame.

M

Mark Parnell

moss99
Hi all , i had my mavic pro crash recently due to the rear left motor stopping looking at the logs iit appeared the motor was still getting voltage but the current dropped , in testing the motor it seemed a little tighter to turn than the others but spinning it ant testing the output voltage it seems to be the same across all phases and winding's seem ok testing with millivolt meter .
Here is a screen shot of motor speeds ,current,volts .
The esc temps seem pretty much the same .
I have replaced the motor but not sure if i should replace esc bord too .
Here is a link to the full log .
I can post the link to flight data if required .

..

current.png motor volts.png
motor speeds.png
 
M

Mark Parnell

moss99
No , no warranty or insurance , i sent logs to DJI , they just want me to send it for repair which will cost a small fortune no doubt , its almost repaired i'm just not sure if i need to change the esc
 
RENOV8R

RENOV8R

Well-Known Member
If you've replaced the motor and it operates properly now, I wouldn't worry. Except in rare instances, ESCs either work or they don't. There's no in-between
 
M

Mark Parnell

moss99
I have not tried it yet , i am waiting for the GPS/compass module to turn up , im just trying to understand what went wrong .
 
mozquito1

mozquito1

Well-Known Member
Threaten it with a soldering iron.
Only hold it like your going to stab someone though. :mad: works for me.
Dji should rename themselves to Jpi
Just Post It.
 
You must log in or register to reply here.
Top