Search results

  1. GJH105775

    FPV Camera dims too much when in light

    The FPV camera with Wide Dynamic Range (WDR) would handle light best.
  2. GJH105775

    Metal standoffs

    The shop I work out of has very few machine tools, the guy is a semi-retired (still doing jobs for his son, church, and a friend), but I can make most anything there, maybe not anyway near as nice though haha.
  3. GJH105775

    Metal standoffs

    Haha i nee a freind like that. You could always buy one a little too big and cut it off.
  4. GJH105775

    oil the motor bearings???

    If you cannot afford expensive oils then 3-in-1 will work just fine or you could just use about nay 20 weight oil. Don't oil right before flying, especially in a dusty place.
  5. GJH105775

    oil the motor bearings???

    If you don't have money for expensive oil just use 3-in-1 oil.
  6. GJH105775

    FPV Camera dims too much when in light

    THis can be fixed if you can find a firmware upgrade that patches this. Otherwise I am afraid to say; you need a new camera.
  7. GJH105775

    Eachine Eachine 3D X4

    When I first unboxed it, I thought that it was just a cheaply made micro-quad that would last five minutes, but after flying it a little bit, I have found that it is REALLY easy to fly and the frame handles crashes well. I have around 5 hours of flight on it and have yet to break a prop, the...
  8. GJH105775

    A new FCB on the block

    Looks great.
  9. GJH105775

    landing gear solution

    Can't see it really good, but it looks like a strain relief and insulator for a lawn mower spark plug. Either way it looks like a great method haha.
  10. GJH105775

    DEVO 10 "Throttle Stick" message won't turn off.. HELP!!!

    Did you try unplugging the power (not just restarting it)?
  11. GJH105775

    My first custom quad

    It'll be a good way to do it, you should be able to look at it and tell about the angle, but if not lay it upside down on a table and it'll fix it's self.
  12. GJH105775

    My first custom quad

    Looking great.
  13. GJH105775

    My first custom quad

    In a landing that may stress the brackets, but in flight that should not be too bad a problem.
  14. GJH105775

    FPV information

    It might. It is not working now, so something has to be done.
  15. GJH105775

    FPV information

    It might.
  16. GJH105775

    Looking for FPV Pilot near Manchester, NH

    Haha yes, I don't see how a state can get rid of constitutional carry, even making people get a permit (I find that a good thing) is restricting to the right to bear arms, the people against bearing arms COMPLETELY ignore statistics, and base it all off feelings.
  17. GJH105775

    My first custom quad

    40 amps on 1240kv motors???? What type of props are you using haha. As long as you use that external BEC you should be fine, you may need to upgrade to 800kv motors later haha, that is what I am doing from my 1240kv motors. I have to buy all new ESCs as I only used 30 amp ones, and I'll...
  18. GJH105775

    FPV information

    They are the same band, is there a DIP switch on the transmitter? All up should be channel 1.
  19. GJH105775

    Naza-Lite and Turnigy 9X

    Neil may be able to help. @holtneil
  20. GJH105775

    Looking for FPV Pilot near Manchester, NH

    Sounds good. One thing; they may try to get you for recklessly flying over traffic, or too close to them, other than that you should be fine, just get a nicer camera, but the audio will be almost impossible unless you use a directional wire mic that could hang from the bottom. On a side...
Top