Search results

I run a few tri blades, in order of likeness. Dal cyclone V2 Dal T5054 King Kong 5045 Emax avan tri & dual. People say different but i started flying gemfan & they where never as durable as Dal props. That's all I was looking for, durability,as a beginner. I've just built a wing but the avan...

On the the configuration tab where esc protocol is. Or is for a brushless setup. Top right, Is there am option for esc type or anything. I've never used a brushed board. But try a board reset & do a fresh setup. The only other advice is what dragger said. Brushed should be a simple setup. As no...

I never got round to the maiden as still having an issue with arm & throttle. Endpoints. 1105 1500 1900 1000 All modes are on correct channels Aux channels on right switches Rx tab in inav all corresponds. Only when I arm, it throttles upto about 25% (no air mode) stick does nothing. & to...

Did he weld machetes onto the prop shaft or something.

They look the same, nearly Both have GCU on em. Good find.

Says GCU on it, just thought it may be similar. I couldn't find anything. Just dji stuff, no GCU.

That's a hard search, bit maybe it's somethingike this one. Ebay.

Ppl having problems with runcam split. The screen either goes black or freezes. Not good.

If your killing boards, just get the F4 pro. I've never seen that AIO board before. Or how trustworthy it is. If still learning, just get separates is my advice. Says on some vendors it has an SPRF3 board in it. Yours ain't an f3. Not a common frame so you may need the same board. SPRF3 are...

Cut my leg & hands, but my goggles stopped the last one. Yes I actually hit my own head & snapped the antenna off my gigs. Lucky no blood.

Only if them 1106 are emax, I got a few sets of motors & nothing compares. Otherwise 1307 for 3inch quads.

What you don't want is the amp draw of the motors exceeding that 180 amps or poof.

Dang, you learn fast. :cool: Yeah that will work for sure with that amp rating. Probably up to 5S 6S.

Yes rx/tx = receiver & Transmitter. you would need a futaba compatible rx. Google your tx, you should find a few.

Don't bother with F3 boards now Memory is getting tight & there is just as cheap F4 boards. :cool:

All are compatible As long as your tx/rx are compatible. an FC is compatible with all common RC Tx.

Sold :cool:

Good advice above, especially newbs. Not really any weight difference. If you snap an arm & short anything you only have to replace 1 esc. You can't do anything a 3in1.

Just the rx to go in. I've just decided I'm going to move an antenna to the bottom, trailing back. Maiden in the morning :)