Search results

In betaflight configuration tab you have to set the reciever type to serial and then click i-bus.

I take my X6B recievers and drill out the holes bigger so they'll fit on the stack sometimes, looks clean that way.

My new Tyro79 fell from 75 feet up onto the pavement and suffered a broken arm, destroyed motor, vtx antenna ripped off the board, and the micro runcam case is cracked yet still working. New frame and motor on their way, she will fly again lol.

1. Hold bind button on reciever. 2.plug in battery to drone while holding down bind button, light on reciever should blink. 3.turn on flysky tx while holding down bind button on tx. It should day "tx binding....." or something like that. Light on reciever should stop blinking and stay solid...

Destroyed gopro and burnt up vtx. Quad still flies fine though lol.

Yep check out banggood.com and buy this tiny drone, it is a blast lol!!!

There was a cheap drone that was hackable, the eachiene H8. I believe the drone was like $12 and the cable that hooked up to it was $5. I think you could flash it's tiny board with an acro mode, pretty cool if you want to learn los acro in your living room. If you want to attempt to hack the...

I was on my sixth pack in a row full throttle the whole time I'm guessing something got too hot lol, gonna post the video this week.

Thanx man definently will!

I was thinking about getting one of these too. I've seen video of the gt349 being clocked at over 100 mph lol. It is a seriously fast racing drone.

Tried a 450mah 4s, bad idea lol. Motors got hot enough to fry an egg, and one of the motors actually torqued itself hard enough to rip the screws out causing a crash. Note: do not try 4s batteries with the brhobby 6000 kv motors.

Yeah I'm using a 6" frame and Hypetrain Freestyle 2306 2450KV Grinder motors with 5.5" props although the bigger props might be a little too big for my 35amp escs considering I just had a "Roll of Death" resulting in "gopro sessions death":eek: so maybe stick to 5" props lol.

I'm getting ready to try this one only $15 from banggood: ZMR250 250mm you'll need 5 or 5.5 inch props, 10 inch are for a 450 or bigger with mmuch lower kv.

Welcome aboard if you love quadcopters you're in the right place :cool:

That is simply the best imho for the i6, I have 3 of these and they all rock. They can easily get 500 meters range.

Yeah I just got done doing a "frankenbuild" but the 4in1 I thought was good had a bad esc and then the spracing board fried somehow, 2 hours of soldering down the drain lol but ya gotta try!

Cancel that order and get the fsx6b reciever, the very best:

It might be your flysky tx, those have known issues similar to what you describe but it can be fixed. Take your tx apart and check for lose connections on the left stick.

Frame-5"Meteor Motors-Lumenier LX2206 2400KV FC-DALRC F405 ESC-DALRC 40amp engine GOPRO Sessions Props-Lumenier 5x5.3x3 Gatebreakers

I'm not familiar with that flight controller but the basic operation of most quadcopters is the same. Somewhere you'll have a flight control board with signal wires from the ESCs connected in either soldered or plugged. The ESCs will be soldered into the PDB. The battery plugs into the PDB...