Search results

Just open Betaflight and connect your quad, then run IRC Driver Fixer. You'll see the COM id in the top-right corner of Betaflight change to DFU. You'll now be able to flash your new firmware.

What sized props are you going to use?

You just gotta put on the 680 Pro CF canopy for the cool factor! Here it is on my 650 Sport

Ok, let us know how it goes!

On page 10 of your manual, it states that the vertical range in GPS is about 35 meters. To go higher, you';d have to be in a different flight mode

Also by over-discharging, you should never let your lipos get below 3.5v/cell

Skirt is just a brim that doesn't touch the part, and I also never use it. The only usefulness I can see of this option is that you can get an idea of how your initial layers are going down and if you are having any adhesion issues. I guess it also primes the printer. But I agree, why use a...

Hi everyone, hope you all had a very Merry Christmas!

However, that "$300+" quad will be made of a much more high quality CF frame and will be able to take much more of a crash and will be much easier to repair. That cheap $40 drone will break if you look at it wrong

OK, so you do have enough experience to probably get off the ground and not destroy that fancy new bird in the first couple minutes lol. But you have lots more research to do as you're going to also need batteries and FPV goggles.

Any FRSky transmitter is compatible with any receiver so the choice is yours. I personally would go with the R-XSR which has full telemetry whereas the XM+ only outputs RSSI (radio signal strength). Of course the real question here is when you say "new to drones", do you have any experience...

Are you asking if you should update the frame and ESCs?

Most manufacturing of CCW motors is a thing of the past. The motors that are spinning clockwise are the ones where the nut can come loose and to prevent this just get some 5 mm nyloc nuts. Readily availabe anywhere

Welcome to the forum! Quite a few members here from the UK

It's quite simple actually but you would need to equip your quad with a GPS module and load your flight controller with iNav software. You then have the ability of various flight modes such as position hold, altitude hold, RTH, etc

Hovering is over-rated

Correct

Trim and sbb-trim is more related to airplanes and helis. For example, say you have two aileron servos, and one servo is off-center and the other one is fine. If you can't fix that situation mechanically by moving the servo arm on the gear, you can use sub-trim on only that servo (output...

You could also go with the R-XSR. It is slightly smaller but more importantly, it will provide you with full telemetry. On the flip side, it's reported that the XM+ has slightly better range.

This should help https://3dinsider.com/drone-flight-simulators/