Search results

Then you're good to go

Most communication based modules and CPUs are AC800. But you need to make sure the quad you are interested in has a receiver that is FRSky compatible. More details would help

That lipo would probably fit but may be a tight fit for the HD camera depending on your setup, best thing to do would be to contact SupaflyFPV directly for support. As for the Nano VTX, I wouldn't recommend it for any long range as it's max output is only 400mW and it only has a 3-13v input so...

According to Manual: Press and hold the power button of the aircraft for 5 seconds to power on the aircraft. A continuously short beeping sound indicates the aircraft is self-checking, a long beeping sound indicates self-checking is complete and the aircraft is ready to fly. Press and hold the...

It's a Revolt by the looks of it, so it'll use FlightOne firmware. Here's a link to the Configurator anf the firmware downloads https://flightone.com/download

Looks like a decent list, just a couple things I'd change up. When you say the Immersion VTX, I'm assuming you mean the Tramp. I'd change that to a TBS Unify Pro, smaller size and higher output. As for the battery well that's about twice as big as is is even practical. In LR, there's a fine...

The biggest limitation is obviously going to be the weight factor and the battery in particular. But you can also use the battery in your favor by top mounting insead of bottom mounting for more snap in pitch and rolls. If you have any doubt as to the agility of these big birds, just do a...

Depends on the build, but if your question is can a 7" do freestyle like a 5", then absolutely yes.

That's why I only use F7 boards now. Never run out of UARTS;)

Yes, the tx/rx wires from the GPS have to go to a separate UART. And remember, on a GPS module it's reversed. TX wire on the GPS goes to RX on the flight controller and visa versa

You'll just have to find a pinout diagram as 2 wires will be for SCL/SDA pads, 2 will be for a spare tx/rx uart and 2 for 5 volts power supply

They just say they're for the Pixhawk because of the connectors which you're going to chop off so that you can connect it to your Airbot FC. So yes, it'll work just fine

Much better do just do internet searches. There's enough online info to last you the rest of your life

Yes, the Cura software is the same for the Ender 3 & CR-10. You may want to update to Cura 4.1 though, the supports in 3.4 are terrible

You say that this happens no matter how high you set the temperature, but your hot end is actually getting hot, correct?

You don't need any cooling off time on the EVO. Change out the battery and send it!

Freestyle frame. Personally if I was putting out that kind of money on a FS frame, I'd go with the Flynoceros Skoll V2. Neil and crew put out some of the best frames on the planet. https://theflynoshop.com/skoll-v2/

Frame - nice Flight Controller - Awesome! Motors - nice, but drop down to 2450kv Transmitter - AT9S, meh (out of date) FlySky is OK, but I'd go with FRSky QX7, you won't be disappointed ESC's - this frame is not designed for individual ESC's. The RacerStar REV35 is a great 4-in1 for the price...

What does it look like in the receiver tab in Betaflight. When you move your stick to full throttle, is it going all the way to 2000 in reciever tab?

Betaflight has a basic RTH capability called GPS Rescue mode, it'll get you back home. Oscar explains it here. https://oscarliang.com/setup-gps-rescue-mode-betaflight/