cc3d wont fly

mason alper

mason alper

Member
I have gone through gcs and configured my transmitter and i try to take off (always armed mode is on) nothing happens.
 
I chose a way to arm it and it did nothing the light on the receiver only blinks when i change flight modes. (i updated my transmitters name)
 
mason alper said:
It doesn't need one it has a 2 position switch under flight modes I selected 2 position switch
Click to expand...

What software are you using, any I know of have 3 flight modes. Rate, angle and horizon or a version thereof so you need a 3 position switch.
 
During your set up in GCS (OpenPilot? LibrePilot? Other?) did you go through the transmitter setup wizard?
Do all your motors react and spin up during the calibration?
Did you go to the arm/disarm page and select an arming method? (Typically, I use the Yaw-Right to arm with NO spin up)
At that point, did you save your settings?
Also, are you using the right protocols for your receiver? (PWM? CPPM?)
There are many possible reasons you're not able to fly. But I would lean toward a missed step in GCS or failure to save after each setting.

Hope this helps.
- Mike
 
mason alper said:
It doesn't need one it has a 2 position switch under flight modes I selected 2 position switch
Click to expand...
As was said why limit yourself to 2? There is a workaround for that old tech radio you bought using 2 switches in combo to get all the flight modes that are available.

Here's a rundown on the flight modes.

 
I got a really nice dx6i for $59.99 and I have a faulty cc3d it fails to calculate level and has x over atti and red over stab
 
You must log in or register to reply here.
Back
Top