Search results

Great, thanks. I'll mark it on my calendar

Sorry for the delay, haven't been on in a while. It's still available, however all my gear is packed up and in storage for a move to a new house in early February. As soon as I'm moved in and unpacked we could discuss a deal if you can wait that long. Tim

Did you happen to check if it increased the print time? Pretty cool though, thanks for the tip

Before you flash inav, go into your CLI and type diff all, then enter. Copy and save to a file and when you go back to betaflight, just paste it back into the CLI to restore old settings

Doesn't seem to exist anymore. Bummer, as this is not a cheap quad. The only solution I can think of is to change the flight controller.

Stand for my Ukulele, 18 hour print

I have the Monoprice Maker Select Plus. I've done lots of mods but quite honestly, not a lot of them are "necessary". There are lots of guys who talk about owning one for 2-3 years with no mods and still going strong. And yes, I use basically Cura generic PLA and PETG settings with just small...

Amazing!

You can control all your devices through extra channels on a correct reciever

It really depends on what country you're from but in general any drone weighing over 250 grams needs to be licenced. In most countries, the height ceiling is 400 feet. RTH is a straight line thing however you need to read your manual as there are many settings. But if you're asking if it will...

What's your budget?

Yes, I had a pretty nice airbrush and compressor. Lent it to my brother and never saw it again

Yes, I'd be interested in seeing what you could do. I've seen some videos of some that have done some very detailed airbrushing and one that he used some watered-down acrylic paint and dirt from the garden to give the bones a weathered look. As for that 250% model, yes I think it took him...

No, actually this is the original size. I saw a video of a guy who did it at 250% and it was the size of a Shetland pony! And if I remember, he did it on a CR-10

Here he is in all his glory, the T-Rex. This is no coffee table piece, measuring a little over 24 inches lol

Wow, your finishing skills are fantastic! You must have a steady hand haha

I agree with mchaos. Plus you're going to have mounting and connection problems.

I've test fitted a couple pieces and they go together quite nicely. I think if I was to go all out and use epoxy filler, I could make the joints seamless with some paint and sanding. But I'm just going to leave it raw, the ivory filament makes the bones look realistic. Although it may be just...

Keep us updated on how far you can get. Great set of instructions BTW

Been busy the last few days, my biggest project by far. I'm just about ready to put it together.