Wallman
Member
Hello everyone!
So I am relatively new to the world of Drones and I have a huge issue I cannot seem to figure out. A few weeks back i purchased an Eachine Wizard 220s with FlySky I6. Out of the box I was able to get it all configured with BetaFlight and was flying in no time!
Fast forward to this past Saturday, I was tinkering around with my controller and BetaFlight. I ended up making a few changes and had to re flash my Omnibus F4 v3 due my mistakes.
Now I am unable to see any Controller input when in beta flight. I.e. When I plug my drone into beta flight it’s able to connect. When I click on the “Receiver” tab it’s not what I’m used to seeing now. The controller will not register when moving the sticks. There is no movement on the bars if I flip any switches. It seems like something is configured wrong after trying to fix my mistake.
I am able to verify that my FlySky controller and FlySky mini receiver are bound correctly. I am able to plug a battery in and use beta flight to test motors.
I have done a ton of research but still cant seem to figure out why im not getting any display from my controller input on BetaFlight
Flysky FS-i6X remote control
Flysky FS-A8S receiver
Thanks a ton for reading!
Wallman
So I am relatively new to the world of Drones and I have a huge issue I cannot seem to figure out. A few weeks back i purchased an Eachine Wizard 220s with FlySky I6. Out of the box I was able to get it all configured with BetaFlight and was flying in no time!
Fast forward to this past Saturday, I was tinkering around with my controller and BetaFlight. I ended up making a few changes and had to re flash my Omnibus F4 v3 due my mistakes.
Now I am unable to see any Controller input when in beta flight. I.e. When I plug my drone into beta flight it’s able to connect. When I click on the “Receiver” tab it’s not what I’m used to seeing now. The controller will not register when moving the sticks. There is no movement on the bars if I flip any switches. It seems like something is configured wrong after trying to fix my mistake.
I am able to verify that my FlySky controller and FlySky mini receiver are bound correctly. I am able to plug a battery in and use beta flight to test motors.
I have done a ton of research but still cant seem to figure out why im not getting any display from my controller input on BetaFlight
Flysky FS-i6X remote control
Flysky FS-A8S receiver
Thanks a ton for reading!
Wallman