First FPV Drone and I'm lost - How To Bind!?!

Discussion in 'Getting Started' started by Adam Adams, Dec 30, 2017.

  1. Adam Adams

    Adam Adams New Member

    I've had a couple of drones to fly around the park and chase my wife, so it's not my first rodeo, but I've only been riding miniature horses until now. I decided to dive into FPV racing drones. I'm so close to flying. I bought the Horus 12S and I understand how to bind from the radio. I bought the Armattan Chameleon 5" BNF. I've got my Aomway goggles. I've got a few 4S batteries. I'm connecting my Quad to BetaFlight and modifying it. I've got the latest flashes for my quad and my radio. I'm ready to go. My goggles work, my quad and radio power up. But I can't get the quad to bind. I think the matter is as simple as me hitting the wrong button.

    The FC has a boot button and I held that down when I powered up to bind, but that didn't work. Just one long constant high pitched buzz. I'm thinking there is a button in the back of the Chameleon on what I assume is the RX because it has two little antennae wires coming out of it. I'm also assuming that I am supposed to be pressing an F/S button while I connect the batter to bind, but I cannot find anything.

    What am I overlooking? Or am I just completely looking at or doing the wrong thing?

    Thanks
    Adam
     
  2. SLFLY

    SLFLY Well-Known Member

    Yes the bind button is on the mini receiver.

    The Boot button the FC is for flashing software onto the FC.

    [​IMG]
     
    mozquito1 likes this.
  3. Adam Adams

    Adam Adams New Member

    Thank you sir. I finally found it and got my bind. It's pretty small covered in shrink wrap, but once I knew it was there I could finally see it. One more step closer to flying.
     
    Rick M and mozquito1 like this.

Share This Page