Brushed FC won't see motors or use accelorometer!

Discussion in 'Tiny Whoops & Other Micro Quads' started by sven, Jul 26, 2018.

  1. sven

    sven Member

    Hey, Sven here, and I'm stumped. I'm using a Betafpv flight controller, and in Betaflight, the accelerometer isn't functioning. Also, when I go into the Motor tab and raise the "Master" slider, but none of the motor bars or motors move. I am so confused, please help!
     
  2. dragger201

    dragger201 If it ain't broke, don't fix it??? You kidding?

    Couple things on the motors. The "Master" slider has an on/off button. Needs to be on. Also, you need to have a battery connected to run the motors.
     
    GJH105775 likes this.
  3. mozquito1

    mozquito1 Well-Known Member

    On the the configuration tab where esc protocol is. Or is for a brushless setup.
    Top right, Is there am option for esc type or anything. I've never used a brushed board. But try a board reset & do a fresh setup. The only other advice is what dragger said. Brushed should be a simple setup. As no esc's to calibrate.
    Just the gyro.
     

Share This Page