flight controller

I am new to drones and I have completed my build for the most part. I'm using a cc3d flight controller, a orangerx receiver and I have a dx6i transmitter. Everything seems to be working good and it connects to cleanflight and I can change all the settings. My problem is that my dx6i shows that...

I have a problem that I am really hoping someone here can help me with. What I Have and What Works For Christmas, I got a Taranis X9D Plus and it came with a X8R receiver. The quad I’m trying to connect it to has an SP Racing F3 FC. I followed the steps to bind the receiver and the Taranis...

Greetings, Ive swapped out my old cc3d FC for the kiss fc but ive been unable to get it going, ive wired it all up, in the kiss gui once i arm it i can see the levels for the motors but doing a test does nothing and the escs wont beep or do anything if i plug the lipo in normally. using 12a...

Recently i built a small racing style drone and i have found that where i live is much to windy to actually have fun flying it as i spend most of my time fetching out of trees or fixing props. I have noticed that all of the high end pre-built quads have altitude and more importantly position...

I have a DIY quad platform, motors, ESC's, props, and an interconnect board. I also have a Spektrum DX7 radio and receivers. What I need now is a flight controller with GPS. Here is what I want to do and the features I would need: I want to do general flying. I am not a racer or photographer...

Hello, It it possible to use the APM Mini 3.1 without a compass ? If i used an external sensor, the GY80 , with a compass chip(HMC5883l) and connect it to the APM Mini 3.1 will it work ? Thank you

Some background information: I am currently trying to finish up a qaudcopter for school in a week or so and so far, i have my frame and controllers done and now i need to connect the ESC's and the flight controller. My cntroler is made from an arduino and some potentiometers with and Xbee shield...

Hi, I'm planning to build a 250 class FPV Quadcopter. I was just wonder if there are any flight controller that is good for FPV racing and also have ability to program autonomous code for the Quadcopter. I was thinking of getting an Ardupilot. Would this be a good fit ? Thank you

Hello, first post and I am asking for help already :) I updated OpenPilot to LibrePilot yesterday and all went well, I had to delete previous software in rescue mode first but the setup process is fine. I can fly the quad and it is stable - until the battery is removed, then all the settings...

I am looking for a FC that can be set up relatively easy for a first flight (won't crash my quad), but that is also highly programmable for the future. I am using my quad for the purpose of eventually getting into PID tuning and programming/GPS integration/drift correction. However, I want to...

Hi guys , im building my first quadcopter and i have already got the below flight controller , http://www.banggood.com/OpenPilot-CC3D-Flight-Controller-Bent-Pin-STM32-32-bit-Flexiport-p-956366.html I am not sure whether its a genuine CC3D or not but what i know is it doesnt support altitude...