Search results

Coming together haha.

Should be able the pull the Tx and Rx ports off from the Minimum OSD and maybe have to Y the 5v to the new Tx/Rx(Bluetooth module)

Minimum OSD's video should be hardwired and inline, so your camera should plug into the OSD, and you take your feed from the OSD as if it were directly from the camera.

To adjust either one just hook it to the power you are going to use, and adjust the pot (rectangular blue part with a brass screw). A 3S battery will be actually around 12v, but they are supposed to be stored around 11.1v. Check out Neil's care guide on this link, it really has a lot of...

Ok, so long story short: No compiler already made, not writing one for 10 lines of assembly. :)

Can C be compiled to assembly like an arduino? They have thesameprocessors?

I am currently at MEPS and can't download anything on this tablet. The discharge method, is it the salt water method?

Thanks for the guide. You should do a thread under coustom programming.

Haha, big as crap batteries, and it is so tidy. My quad is currently is currently sporting ESCs wrapped in electrical tape, because I have a little more to do with them. Mine is anything but tidy and neat xD. I really like looks of it, so what is the current AUG? By my estimates it cost...

@Jackson Thanks for that link. I have looked a little for some good-n-cheap high drain li-Ion cells, to use on another project.

If you go to high and it continues at the same throttle it could end up anywhere and your chances of finding it are sadly small. You could have it set the throttle to a smaller number to cause it to have a controlled decent, if you regain connection before that then great. Also out of range...

Less latency, and not too hard

Probably only need to monitor the LED or throttle.

That is what my cheap one does, you can do this with an Arduino. You could have it come right off from the LED, or monitor the PWM signals. It would not be much (if any) harder to have it cut you to lets say 20% throttle.

I believe that is an issue with the KK, because mine does that. I am using a cheap HKTR6a (Hobby King Tx) and it does the same thing. You may want to invest into something like a Turnigy 9X or Orange transmitter and receiver. If you fly this much it will be a most likely be a matter of...

Hmmm, no sailsafe? What Tx/Rx do you have?

Easy, what flight controller are you using? Usually the outside pin is ground, the middle is 5v+, and the inside is signal. Just use the ground and 5v+

I wonder how big it'd have to get for solar foil to become efficient?

PDB in this case. Try getting the 5v+ from your receiver or FC first though. It may not be as bright, but still could be enough.

Welcome to the forum. I have seen a few people now able to get flight times of over an hour. By using Li-Ion batteries. You really have to limit the current that the quad can draw. But they get longer times because you don't hurt them by discharging them too much. But 43:13 is a really...