Search results

One I did, and one came pre flashed.

I used 8 on my mine. Nice tiny rx!

I just recently got a Naza Lite, and did the firmware upgrade, and so far it has been a solid controller. It is not instant takeoff like my Naze32, but it is more of a progressive launch. I do not think that the flight controller is what is causing your vibration issues. It could be the motors...

lol...

Yeah. It works as expected. The issue is if the gimbal has a twitch it seems to send some kind of voltage back through the signal and ruins the flight controller. Maybe I just need to invest in a better gimbal.

Sounds like one is actually faulty, but the other seems to be ok. Check the mapping in cli by typing map and hit enter. The throttle should change on input. Make sure all of your channels are mapped correctly for your reciever. If you are not sure you can test one at a time to figure out the...

Do the motors spin correctly when using this screen? If they do not then I would call it a malfunctioning FC.

I am not familiar with Open Flight. Have you tried to flash Clean Flight or Base Flight, and see if it functions the same way with those?

Does motor 4 spin using clean flight or base flight? Do you know if the fc mapped correctly for your rx? I have received a bad fc before, and was able to rma once I proved that it was an issue with the fc.

What are you installing it on, and what makes you think they are faulty?

I was hoping so, but I just wanted to make sure I was thinking correct. Thanks!

"Hi DJI Naza M v2 , or if you very quick the DJI Naza m lite and flash it with the Naza M v2 firmware" What do you mean by "very quick"? I am just asking since this is in my future plans :)

I prefer Cleanflight because it has more gui options.

I am having an issue with the signal causing feedback into my fc and causes it to burn up. It works well until the gimbal seems to glitch. I have had this happen on two of my fcs so far and trying to elimate this from happening again. I am using Naze32 and a cheap gimbal. I have the signal...

Thank you both for your advice! I'll stick with 10inch props. I made adjustments to the p gain and it seems to have helped :)

Thanks GJH! The tx is fine as I run two other quads on it just fine, they are just smaller. This is my first larger quad. I will try to take some video of what it is doing tomorrow and post it. Do you know if there a setting on the Naze to adjust the re-level settings?

Hi All! I have just completed a 500 build. I am having an couple of issues with it though , and I am not sure what the solutions are. Any advice is appreciated! The first issues is that I have balanced all of the props, but it is jumpy while hovering with both 9 and 10 inch props. (my 250 is...