Terryfrank84
Well-Known Member
please can someone help me with setting up naze 32 as I think the 2 I have bought are both faulty.
Faulty naze32
- Thread starter Terryfrank84
- Start date
Terryfrank84
Well-Known Member
Hi mate. Basically, I've got 2 quads that I'm building. Both exactly the same setup(frame, motors, esc's etc). I flashed them both and installed the latest firmware like the video says. But on one fcb everything works but motor 4 doesn't respond, so I changed both esc and motor still nothing so I know it's not that. And on the other fcb it won't recognise the transmitter properly. The throttle will not work.
Terryfrank84
Well-Known Member
The fcb that doesn't work with my transmitter, in using spektrum gear.
And the other board, just won't spin up motor 4.
They are both using open flight.
And the other board, just won't spin up motor 4.
They are both using open flight.
Terryfrank84
Well-Known Member
I re flashed both with base flight and still get the same problem with both boards
Terryfrank84
Well-Known Member
Yes they all spin fine using this screen with one of my boards, the other one doesn't.
And on the one that does work on this screen. When I then go to the screen where you have to set all your centres up on the sticks at 1500,(sorry I don't know the technical name for it ) that's where the throttle doesn't work.
Sorry I sound like such a newb but I really am stuck.
And on the one that does work on this screen. When I then go to the screen where you have to set all your centres up on the sticks at 1500,(sorry I don't know the technical name for it ) that's where the throttle doesn't work.
Sorry I sound like such a newb but I really am stuck.
ringolong
Well-Known Member
Sounds like one is actually faulty, but the other seems to be ok.
Check the mapping in cli by typing map and hit enter. The throttle should change on input.
Make sure all of your channels are mapped correctly for your reciever. If you are not sure you can test one at a time to figure out the way it should be mapped.
Check the mapping in cli by typing map and hit enter. The throttle should change on input.
Make sure all of your channels are mapped correctly for your reciever. If you are not sure you can test one at a time to figure out the way it should be mapped.