Search results

You listed 2 ESCs if you don't already have XT60 ends I'd suggest you get this instead of the PDB you have, also this to wire in the voltage buzzer on the KK.

2 minutes? Hahaha, list your specs and we can look for a battery to give you a little better flights times.

What ESCs are you using? You might need either LVC enabled (don't do this if you are going very far from your takeoff) or have a voltage buzzer. What size battery are you using now...

Hahaha, sounds great!

No need to open it, it is a single board quad, and you can't use a hobby rx in it. Also I think it uses proprietary protocols for the radios. Hahaha, that is actually a really nice quad, especially for that price.

Your servos should be PWM, test them by plugging them into your rx. You also may have to change some settings on your radio to get the AUX to work.

Hahaha, yeah and they'll over pay for something that could be don much cheaper and a lot simpler hahaha.

Yeah, many people put their name and phone number on their quads as it is. As inefficient they are at getting things done I would not be surprised if it took them until June or better hahaha.

If the receiver is built in or the motors are DC it is unlikely that it will work. Can you get a picture of the quad? (stock or otherwise).

Sounds good, haha. Will do.

http://www.hobbyking.com/hobbyking/store/__43884__MT2213_935KV_MultiStar_Motor_and_Propeller_Combo_10x4_5_CW_CCW.html

A multistar bundle I think there is a 980kv motor bundle for a good price.

Wow, 4 of those are going to cost you a pretty good bit, I think you should not go lower than 700kv for yor frame size, 800kv would be in the sweet medium. Also those motors look to be made nice, but the specs were listed like cheap parts as they did not list the type of bearings, magnets and...

~900kv motors ~$13-$20 x4 30 amp ESCs ~$8 - $13 x4 Some 12''x3.3 props 1 flight controller $7 - $1,000 Take a look at this link to decide. for simplicity's sake I suggest a kk2.1.5 Power Distribution board or cable ~$5 Radio and receiver $20 - $$$$$ dependent on your preference and budget...

If they try to do registration of people to fly rather than aircraft that can fly they may get into some really sticky legal situations.

might not be for servo gimbals, also the gimbal should only move when there is a camera on it and the quad is armed.

For these motors and ESCs I would suggest a 450mm or 500mm sized frame, some 12x3.3 Slow Fly props, a 3S 3500mAh - 5200mAh battery, and a power distribution board (if it does not come with the frame).

Haha, yeah, unless it comes to talking about them then the media makes sure you know that these things could be 40 pounds!

Well that is nice, but I'd hope to see the bar set higher hahaha. Many SYMA sized and FPV racers are still regulated under that.