Search results

Honestly it could be the same everywhere however there are many folks who are planning on ignoring the new rule. For a little hope check out the rotor riot facebook page. They're planning mass non-compliance lol.

You ain't from around here and it shows. They might get away with some fed bs where you're from but not here lol.

Here in the lou (St.Louis) I can't even get the police to shut down the active meth lab down the street from me, doubtful that they'll care that I'm flying below the treetops in the park lol. Also note it says remote id rule, not law.

Caught by who? The FAA cops? This seems like unenforceable government overreach to me.

Bad news for people who fly dji type satellite controlled drones that have to update before you can fly.

Ah yeah it's probably a bad motor or esc, not too expensive to replace. Do you solder?

I can't get my og wizard to connect to betaflight's recent configuator it will only connect to the old bf chrome app. The f3 fcb is no longer supported. I'm running cleanflight 2.0 on my wizard, you might try connecting with the chrome app, hope this helps.

Is it an og wizard (20 amp single escs) or one of the many wizards with a 4in1?

If you get it to bind just a normal setup in betaflight is all that's required.

Put a stop payment on your credit card that'll kick those Shenzhen f@cks into gear.

You got screwed

I had a similar problem re-flashed betaflight 4.1 and the problem went away. Worth a try and don't cost anything.

Yep LOS is fun with those big drones but I'll fpv my 450 but with inav you should theoretically be able to do either.

Don't use the mamba fcbs they have issues.

Also may I recommend checking out all the components the tyro 129 uses this is a diy kit that comes with almost everything you mentioned in your post...

For video you could use the dji air digital fpv system should do 1km no problem. Any f7 flight control board should be able to use the inav firmware so you'll have gps return to home. You'll also need to hook up a gps. Other than that just get some motors, escs, reciever, transmitter and props...

I can't say for certain but it was probably a faulty flight controller that is weird though sorry to hear about your lost kwad. This is one reason we shouldn't fly these tiny high powered flying blenders around people because stuff happens sometimes out of our control.

Your video is not working you might have to have a slightly higher post count to be able to post videos. Try a thread in the introduction section.

No you'll have to follow all the steps on flashing your firmware, just follow the steps on the flash page and there many youtube videos on how to do it.