X8HG opposite control on the joystick

Jaked'snake

Jaked'snake

Member
Just got my X8HG 2days ago, i've noticed the left joystick when i 've tried up and down motion to start-up show no response while on the right joystick did the same motion and it works., all the functions of left joystick and right joystick works opposite!! descending and ascending to the right joystick, left and right turn to the left joystick.. Any comments or suggestions??
 
The transmitter has two operational Modes. NOTE: The mode setting
changes the location of the control stick where the roll (left/right) and yaw
(rotation) are located.
To change Mode, Hold button B to the right while turning on Controller's
power switch.
Mode 1:
left stick = elevation & yaw (rotation); right stick = pitch (forward/reverse) & roll (left/right)
Mode 2:
left stick = elevation/ roll (left/right); right stick = pitch/ yaw (rotation)
To change (toggle) Modes, push button B to right then turn on the transmitter power.
NOTE: Mode 1 and 2, as used for the X8G, are different from "standard" RC conventions. The X8G
mode definitions result in Mode1 being the same as the industry "standard" Mode 2 and Mode2 is
what is normally called "Mode 4" in the industry.

upload_2017-3-31_4-47-48.png
 
I've already done that switches to mode 2 but if i switch on the power on the remote control push the lever up and down the lights continously blinking, how ever if i use the right joystick, the blue light stop blinking..
 
If it turns on the left joystick and it throttles on your right joy stick, then I would think something is wrong with your controller....................maybe need to contact the seller............
 
Jaked'snake said:
I've already done that switches to mode 2
Click to expand...
With Syma you have have to set it to MODE 1 if you want the real MODE 2.

Jaked'snake said:
the power on the remote control push the lever up and down the lights continously blinking, how ever if i use the right joystick, the blue light stop blinking..
Click to expand...
Having to use the right stick to bind is because you are not actually in real MODE 2 (throttle on left.)
 
Jackson said:
With Syma you have have to set it to MODE 1 if you want the real MODE 2.


Having to use the right stick to bind is because you are not actually in real MODE 2 (throttle on left.)
Click to expand...
Can you explain how to do that?? I 've tried it many times on the left joystick in mode 1 and 2 but no success.
 
When you turn on it on do you now see mode 2 on the screen? If so change it so it reads mode 1 (which is the real mode 2.)
dragger201 said:
To change Mode, Hold button B to the right while turning on Controller's
power switch.
Click to expand...
upload_2017-3-31_4-47-48-png.2561

When you do this this you'll hear a longer beep instead of the typical chirp you get when simply turn on the TX.
 
Back
Top