Turnigy/Mode 1 to Mode 2 Conversion

Candungo

Candungo

New Member
Hi to All....
I did a firmware update on my 9xr pro radio (V.1760-Mike 4/12/16 ersky9x-r220) plus mode 1 to mode 2 conversion (no soldering /parts swap) and cant find a way how to reset the idle throttle alarm after the firmware update.How do you go around this?
Thanks ....
 
My Radio is a Turnigy 9xr pro..
When Switch ON a Throttle Warning shows up then I press:
MENU/MODEL SELECT *01 New Quad.
MODEL SETUP
Mixer/Heli/Limits/Expo-Dr/Modes/Curves/L.Switches/Music/Safety Sws/Globals/Telementry/Voice/Timers/General/Protocal.
RADIO SETUP
Display/AudioHaptic/Alarms/General/Control/Hardware/Carlibration/Blue Tooth/Trainer/Version/FrSky xSSI/EEPROM/Date-Time/Diag. Switch/Diag.Ana.
No Quad Templates, I selected Simple 4-CH..
I have the Coffee pot ready...lets do this ..
 
Radio Set Up/Controls/
Channel Order is set to RTEA
Cross Trim is not selected
Throttle reverse not selected
Mode 2
Rud/Thr/Ele/Ail
ch 1 2 3 4
I exit pressing Menu then turn it off /0n and the Throttle Warning shows again...
 
Back
Top