anyone use one of these can I get some help please at a loss on wiring it in and connecting power. Teeny F3 6DOF integrated PDB 20x20mm flight controller. https://m.ebay.com/itm/Eachine-Aurora-F3-Flight-Controller-2-4S-BEC-PDB/292311104588
Teeny fc
- Thread starter Cavcareer
- Start date
Jackson
USA member at large
Jackson
USA member at large
I think this is the latest version.
https://www.banggood.com/Eachine-Mi...mUjNevWdxCI_qBhoCEEkQAvD_BwE&cur_warehouse=CN
https://www.banggood.com/Eachine-Mi...mUjNevWdxCI_qBhoCEEkQAvD_BwE&cur_warehouse=CN
So directly connect the battery to the board. Will this thing handle 11.1v without frying? It says 2-4s,
What I’m doing is taking everything off of my old frame and putting it on a smaller one. I’m not using the cube esc, I’m using my old escs an motors!
Do I use the power distribution board I have, or connect my escs to this thing? It says it has a intergrated PDB!
If so what do I do with the groun on the grd and signal wire from the esc?
What I’m doing is taking everything off of my old frame and putting it on a smaller one. I’m not using the cube esc, I’m using my old escs an motors!
Do I use the power distribution board I have, or connect my escs to this thing? It says it has a intergrated PDB!
If so what do I do with the groun on the grd and signal wire from the esc?
RENOV8R
Well-Known Member
Yes, you connect your battery direct to the board. Wiring diagram is here
http://files.banggood.com/2016/12/MiniCube F3 V1.1 6DOF integrate OSD Manual.pdf
http://files.banggood.com/2016/12/MiniCube F3 V1.1 6DOF integrate OSD Manual.pdf