Syma X8W Controller Signal Keep Flashing

N

Neil24

New Member
  1. Hi,

    I recently bought a Syma X8W and I am trying to fly for the first time however it seems like one of the motor is running slower then others and Remote Control is showing the signal keep flashing. Can you please help and do you know why the signal keep flashing? I have already full charged the battery and try to calibrate and re-sync few times.
    The Drone wont fly due to one propeller moving slowly then others.

    Thanks!
 
Try leaving it run at a very slow speed for a few minutes.

If it's the first time you may have a bad quad. How does the lazy one feel when you spin it by hand?
 
I try to leave it on for few min on a slower speed but still the same thing. When I move the speed all the way up it seems like one side lifts up much faster then the other and then it flips on one side. When I manually spin the propellers with the finger it feels little bit tight but they all move, its kind of bumpy but they all move though. Its just not lifting up, its just keep flipping on the same side....It may be that one side propellers are moving faster then the other. I have tried re-calibrating, resetting, changing mode, put the new batteries but same results....Also I am not sure if the signal on the remote controller should always be blinking or is it an indicator of something. Thanks.
 
Neil24 said:
... When I move the speed all the way up it seems like one side lifts up much faster then the other and then it flips on one side.
Click to expand...
You had to put the props on I assume. Double check their placement. There are 2 As and 2 Bs, they are marked as are the arms.

Does this look like your problem?

 
Back
Top