Reciever getting mad signals

[Sportinger]

Hello everyone,

i have build a micro quad and have an issue with the reciever.
I connected the LR1000 (frsky from furious fpv) via SbUS to my FC (HGLRC XJB f428).



after binding i get somehow crazy signals which can be influenzed by moving the stick on the taranis. I think this ais related to the wrong serial reciever provider which is set to spectrum by default although i got frsky. But if i switch to SBUS i dont get any signals at all



Iam obviousy doing something wrong. If somebody could give me a direction to look in, would be great !



all the bests,

Sportinger

 

[holtneil]

Hi mate just for a test disable the FPV this some times makes the receiver play up
I think Sbus needs to be turned on in the transmitters well FCB

 

[Sportinger]

i didnt install the VTX yet, just the Camera signal into the FC. should i disconnect this ? As one can tell iam not that familiar with everything, started half a year ago with tiny whoop, that was no problem. This is "the next" step for me
on first build, i connected PPM from the board to the telemetrie on the reciever and sbus to sbus. A friend told me that this was not right because one ether needs PPM or Sbus, but not both. Perhaps i fired the reciever ?

 

[Jackson]

Have you run through the calibration steps, accelerometer etc?

 

[Sportinger]

Have you run through the calibration steps, accelerometer etc?

i did a factory reset, calibration on the Betafight setup page, the one click thing.