Quadcopter yaw spin/drift

F

Frederik

New Member
I have recently build at quadcopter and it started working out fine, but i have made a factory reset on my kk2 controllboard because i have messed some settings up. after factory reset i followed the same youtube setup guide as i did the first time. But now it have started to yaw spin/drift )
If i push my rudder as much as i can to right i can only hardly hold it, but it stil spin slowly.

I can't figure out what there is wrong, i have double checked everthing i hope you guys can help me fix it :-)

My setup:

kk2 controller
Q brain esc
ntm propdrive 28-30s 800kv
super h 600 frame

My yaw spin/drift on video:
Youtube setup guide:
 
Were all the trims on your tx centered when you did the setup? Are all the props in the correct location with leading edge spinning the direction of the motors?
 
The trims is centered and i have tried to trim so much i could, to make up for the spinning but it dont work. Yes all the props are in the correct location and is spinning the correct way.
when you ask about my trims was centered under the setup, what do you mean with that? Do you mean it in realtion to my kk2.0 setup?
 
When you setup the kk2.0 were all the trims centered on the TX? I'm not familiar with kk2.0 but can you see in it where it thinks the sticks are when in centered. I know when I setup my cc3d using LibrePilot after setting up the quad I have to setup my TX part of this is setting stick limits in all directions. When finished I can more the sticks and see what the FC is seeing. It will also show be where it thinks center is on each stick.
 
I have now factory reset my kk2 with my trims centered, and i can see on my kk2 that the trims is centered but it didn't help. When i fly two of my motors get warm, and the two others is cold. have you any other ideas on how i can fix it?
 
Back
Top