Quad Won't connect to Goggles!!!

[IsaacS]

Hi, my drone's VTX is a TS832, and I also have an RC832 Reciever. I have Quanum v2 DIY goggles, and everything is wired correctly (camera and VTX are directly soldered to PDB). When I turn everything on, the goggles just display static and say "NO SIGNAL." I've been through all 40 channels/frequencies on both the vtx and rx, but there is no video. However, everytime I do something like change the VTX's channel, the static in the goggles changes. I'm a noob at this stuff, please help!

 

[RENOV8R]

If you're seeing changes, it's possible that your antennae are mismatched.

 

[mozquito1]

Either that or you need to change the ground wire, if I remember right
Either join the 2 ground or put em on different places.
A silly one but did you take lens cap off.

 

[mozquito1]

I used a step-down because this was my pdb @the time.

 

[IsaacS]

I've tried everything that's been suggested on this page, but nothing has worked....

 

[mozquito1]

Change one of the ground wires again.
Did you join them together.

 

[IsaacS]

Join what together?

 

[Gyro Doctor]

... Moz, the way your schematic is drawn there's a direct short between pos and neg at the cam !

 

[mozquito1]

Sorry,my bad. yes I put the cam signal wire to the pdb . The picture underneath is right though. That was a working system that was supplied separately from the lipo.