programming cc3d help please

J

johnathan

Well-Known Member
Gsc is the program I use right? Open pilot gsc? I fet this error, how do I correct this..
 

Attachments

  • 20160326_120234.jpg
    20160326_120234.jpg
    286 KB · Views: 5
Well I got past that. Now im on the esc calibration procedure, and im suppose to hook the battery up and wait fir the beeps then disconnect the battery, but when I connect the battery, they all keep beeping and wont stop, I finished the step without it finishing then the bext step to find the idle speed, it doesn't spin the motors
 
Fixed that part too.. I had to connect the battery again, I habe a problem now, I set the x8r up to the cc3d using sbus. I have my transmitter and receiver paired, but my transmitter wint work the.motos, on the openpilot gsc program when I calibrate the controller it doesn't recognise my inputs. can someone please explain this to me?
 
I don't know about Openpilot, I use Cleanflight. But default for input is usually PWM, you would have to enable S-Bus
 
Your link didnt work. I couldnt find libre pilot, I was able to get everything ti working.. but.. now it wont fly, some motors turn sometimes other times they dont. It just flops on its belly when I try to fly it..
 
Now libre is giving me about the same message... pribably bc I flashed the open pilot to it. Gah, whats a uploader plugin??
 

Attachments

  • 20160326_180839.jpg
    20160326_180839.jpg
    355.1 KB · Views: 2
You must log in or register to reply here.
Back
Top