Neil Bailey
New Member
Am a Quadcopter newbie and loving the hobby so far. Only using a Syma X8C with SJ4000 cam mounted. Still a little jello on the footage but thought i would share what i have so far.
Newbie with some early flight footage
- Thread starter Neil Bailey
- Start date
Jackson
USA member at large
Not too bad. Did you balance the props? How did you mount your camera?
These will take care of the visible legs, bolt right up.
http://www.banggood.com/FC-DJI-Phan...ghten-Broaden-Landing-Gear-Skid-p-920118.html
These will take care of the visible legs, bolt right up.
http://www.banggood.com/FC-DJI-Phan...ghten-Broaden-Landing-Gear-Skid-p-920118.html
Neil Bailey
New Member
Jackson,
Thanks for the reply - No i have not balanced them will look this up and sort that.
The camera is mounted using lightweight plastic case which just about fits the camera however is very secure. I have purchased an adapter from banggood which replaces the original camera mount and allows a Go Pro type locking bolt to hold the camera and mount.
And cheers for the link
Thanks for the reply - No i have not balanced them will look this up and sort that.
The camera is mounted using lightweight plastic case which just about fits the camera however is very secure. I have purchased an adapter from banggood which replaces the original camera mount and allows a Go Pro type locking bolt to hold the camera and mount.
And cheers for the link
Jackson
USA member at large
Is this it?
His footage at the end looked pretty good. Using screws to mount it though is unnecessary and adds weight and complexity, some good double faced foam mounting tape (the permanent, outdoor type) would be easier, lighter and also help to further isolate the assembly.
He used the solid plate on top, the slotted one will probably fit right between the Syma tabs that he removed, Banggood shows it with 2 slotted plates.
His footage at the end looked pretty good. Using screws to mount it though is unnecessary and adds weight and complexity, some good double faced foam mounting tape (the permanent, outdoor type) would be easier, lighter and also help to further isolate the assembly.
He used the solid plate on top, the slotted one will probably fit right between the Syma tabs that he removed, Banggood shows it with 2 slotted plates.