new drone soon to be first build

[Rookie just starting out]

so i had recently purchased a usmile 250 mm carbon fiber frame i was curious since the motors are already on there way what type of flight controller and power distribution board i would need i was comparing these 2 and id like 2 know which is better so that i might be able to buy the right one one of them is a naze 32 direct input voltage part the other is a arco naze 32 rev 6 with pin headers

 

[poolman966554]

most flight controllers only wanna see 5v from a bec or pdb, unless you have a flight controller with onboard pdb..

Forget Naze32.. its old tech. get nothing less that a f3 board.

 

[mozquito1]

Listen to poolman F1 board will be no longer supported soon, the chip is too small for all that data. What size are the motors? But usually 20amp esc will do unless you using 6S battery, in that case you will 6S capable esc's 30-45amp.
As for the pdb just grab a Matek with
5&12v out. I get em on ebay for £5.

 

[Rookie just starting out]

I also need to know what I could use as a transmitter and receiver I'm using 2,300 kv motors

 

[QuadKid]

Taranis X9D TX will support most anything you build, I use a frsky x4r-ii receiver, binds nicely to TX, Foxeer 200mw VTX for FPV, Running BL_Heli Race Star 2300KV motors, BL_Heli Race Star 30A ESC's

 

[Jackson]

Best deal out there for folks on a budget.
https://www.banggood.com/Flysky-FS-...6B-i-BUS-Receiver-p-1090406.html?rmmds=search