NAZA M V2 will not respond to TX

[coolhuh]

I just put on the NAZA M V2 w/GPS. I am using a Tranais X9D +. with X8R receiver. I was able to bind them but the quad will do nothing. I connected all the wires according to the DJI website. The reciever has a solid green light and the PMU has a blinking green light.

I previously had the Hobby Power kk2.15 flight controller on it and it flew now with the NAZA nothing.

Motors: MT2213 935kv
ESC: Simon k 30A
Battery: lipo 11.1v 2200mAh.

Any suggestions?

Thanks

 

[ringolong]

Have you calibrated, and setup the radio to the controller in the assistant software?

 

[holtneil]

Hi also to arm is different than the KK , try both sticks down and to outer corners to arm then down and towarfs each other to disarm

 

[coolhuh]

When I hook up to the assist program it says I need to connect to controller. Nothing will work on assist. I plugged the USB into my quad and the green light is on, on the receiver. When I try anything with the transmitter, nothing happens.

 

[ringolong]

Is your radio binded to the rx?

 

[RENOV8R]

When you connect the USB, is the Naza's LED unit faint green or very bright, and are you connected to the Naza via conventional or S-Bus?

 

[coolhuh]

I am binded to RX, the green light on top is solid green.

I am connected via S-Bus and the led is a faint green when connected to USB and quick yellow flashes when not connected

 

[Jackson]

When I hook up to the assist program it says I need to connect to controller. Nothing will work on assist.

Try another USB cable, they are not all the same.

 

[coolhuh]

I am also using windows 10, if that has any thing to do with it.

 

[coolhuh]

The USB cable came with the NAZA, I also tried another and still nothing

 

[coolhuh]

When I move the SE switch on channel seven it changes the LED. All the way back and all the way forward makes the LED blink yellow very fast. In the middle it blinks 2 yellow fast.

 

[coolhuh]

The assist will not connect to the controller. When I press a button in assist it says "Please connect to the controller"

 

[Jackson]

When you plugin/out your USB cable into your computer are you getting the appropriate sounds?

 

[coolhuh]

Yes, the computer makes the sound when I plug in the USB cable

 

[RENOV8R]

I am also using windows 10, if that has any thing to do with it.

Never noticed this before, here's your fix hopefully. I had the same problem and this worked

 

[coolhuh]

Windows 10 was the problem. I had an old laptop that has windows 7 and it connected to assist.

Thanks everyone.

 

[RENOV8R]

The problem is that Win 8 & 10 have added security and the DJI software is unsigned (If you look at the properties of their software you'll see Publisher:Unknown) Pretty ridiculous that DJI can't sign their software and you have to put your PC at risk by going into unprotected mode and do a forced install of their drivers. But glad you got if figured out. Happy flying!