Naza-Lite and Turnigy 9X

I

IndianMessi

Well-Known Member
I am trying to configure my 3-position switch... But my throttle controls my flight mode! I have checked my channels. Please help!

Thanks!
 
Hi mate , a few things to look at ,set up transmitter as a basic Aero NO mixing , this should stop the problem , then set up the switches on the transmitter ,after go into Naza assist power every thing up ( NO PROPS ON ) this will let you tell the FCB what switch is doing what CL/HL/return home etc , if you flick the switches you will see the mode change in the Naza assist if its set up right
 
Hi it will be in the basic set up some where your need to look at the manual it will show you how to assign switches to modes
 
Hi been thinking if you use the flaps switch which is a 3 way switch, you just need to find the channel on the receiver it controls, this will give you flight modes , the Naza uses 2x 3 way switches , 1 does CL/HL/ the other does GPS /ATTI/ATTI normally set one of the ATTI to manual mode
 
For some reason my elevator is always at max... I have calibrated many times with no different result... When I put it at lowest setting it shows up as centered.
 
You must log in or register to reply here.
Back
Top