how to connect flysky i6 receiver to ardupilot 2.5(wiring)

lefteris

lefteris

Active Member
hi guys I am new here and I want some help. I got the ardupilot 2.5 and a flysky transmitter -receiver and I don't know how to wire the receiver and ardupilot. what connectors I have to use and what pins?
 
You need some Male to Male Servo Extensions. Like these:
http://www.ebay.com/itm/New-10PCS-5...985314?hash=item4ae86c3462:g:RPgAAOSwBahVL2u7
http://www.getfpv.com/accessories-7...e-5-pcs.html?gclid=CP78-eyok8wCFQyEaQodMQMHYg

Figure out how long you need, many places sell them.

Is this your RX?

SKU255103-1.jpg

Note the polarity at the bottom, the black wire of the lead needs to be at the outside edge ('-').

Going by your avatar simply connect the cables in the same order 1to1, 2 to 2 etc, again paying attention to the polarity on the APM. Black goes to '-'.
 
His avatar must be the one he has, my explanation was straight forward. That Heli pic of yours just muddles things. :)

5931.jpg

​
 
I connect the wire correct but my fs-i6 transmitter not response with ardupilot 2.5 why? the receiver is powered but when I try to fly with trasmiter control nothing happens why?
 
lefteris said:
I connect the wire correct but my fs-i6 transmitter not response with ardupilot 2.5 why? the receiver is powered but when I try to fly with trasmiter control nothing happens why?
Click to expand...
You need to bind your receiver to your transmitter. Your receiver(Ardupilot 2.5) should have came with a bind plug.
 
lefteris said:
guys I do it all all is ok but when I press throttle only 3 motors spin why?
Click to expand...
Check all of your connections. Depending on your flight controller software you may need to select that it is a "x quad" if tricopter is the default. It's also possible that you have a bad ESC or motor. If your 4th motor is twitching you have a bad ESC and should uninstall it before something bad happens.
 
Back
Top