Hi, I need help with my first build having a problem with my Turnigy receiver.

[J0kerJ4y]

Hi everyone so this is my first build. The issue i am having is that i have no idea high to connect my flight controller to the transmitter. I have a Turnigy 9x V2 and a Naze32 revision 6 flight controller.
How do I connect it for the receiver and the transmitter to work, in other words how do I set it up? I run v1.13.0 on clean flight.
Please help.

 

[Jackson]

Well if it helps the Turnigy/Flysky RX channel mapping is A, E, T, R for 1, 2, 3, 4.

 

[J0kerJ4y]

Thanks a lot but how would I plug the wires in from the flight controller into the receiver.

http://www.hobbyking.co.uk/hobbykin...ight_Naze32_Rev6_Flight_Controller_Acro_.html

http://www.hobbyking.co.uk/hobbykin..._Module_8ch_Receiver_Mode_2_v2_Firmware_.html

 

[J0kerJ4y]

My transmitter is PPM

 

[Jackson]

My transmitter is PPM

I don't think the RX is PPM, you will need to use separate wires for the channels.

The links are dead, HK is down.

 

[RENOV8R]

Different receiver but same setup. Just check your manual to which pins to plug in to

 

[RENOV8R]

Yeah, overview says 2 channel PPM