Help setting up receiver to SP Racing F3

So i'm totally new to drone building, started around 2 years ago but never got the thing finished. Right now, I am trying to set up the receiver, which is a FlySky F6-T6. Following the documentation with the board, i connected it to the receiver using the flex cable. When I power up the board and have it plugged in with USB with CleanFlight open, i receive no input from the receiver, all values stay static. The serial link status also starts flashing, im not sure what this means.
Any help would be appreciated
Thanks :)
 
Your modes need to be setup along with Aux channels (Arm & modes switch) before input is received in the rx tab.
Also pwm selected in rx type on configuration tab.
I had an fsi6 that does pwm, ppm, ibus.
I'm not sure about the T6. What cables came with your rx. 8 x 6 servo plug adapter. If so it's pwm. 1 wire for each channel with +-
 
Thank you both so much, using what you both sent me, i was able to get some input from the receiver. Just needed to plug all the Aux's in thanks guys :)
 
Back
Top