FlySky FS-i6 wont work after CleanFlight firmware update

In the picture where are the ground wires off the esc's? I think they should be on the edge of the board. I can see you have power & ground on them rails.
 
mozquito1 said:
In the picture where are the ground wires off the esc's? I think they should be on the edge of the board. I can see you have power & ground on them rails.
Click to expand...
I have a 4in1 20a esc so the ground and power connect directly to the PDB.


After I reset the flight controller (new firmware, everything), I put the props on like you suggested and it flipped over. But then I remembered I'm prone to putting the props on upside down... so I dbl checked and they were on incorrect. Fixed the props and then tried again... Lift off.

What sucks now.. is that I lost 3 screws to a motor on the test flight and now its grounded till I get more screws.

Fix 1 problem, 3 more rise.
 
Well seeing as your ordering stuff. Get some blue loctite. Or a cheaper version.
It will stop them screws vibrating loose.
Make sure to tighten all screws before everytime yo go out. Get some nylock nut for your props if not already.
 
Back
Top