In the picture where are the ground wires off the esc's? I think they should be on the edge of the board. I can see you have power & ground on them rails.
In the picture where are the ground wires off the esc's? I think they should be on the edge of the board. I can see you have power & ground on them rails.
I have a 4in1 20a esc so the ground and power connect directly to the PDB.
After I reset the flight controller (new firmware, everything), I put the props on like you suggested and it flipped over. But then I remembered I'm prone to putting the props on upside down... so I dbl checked and they were on incorrect. Fixed the props and then tried again... Lift off.
What sucks now.. is that I lost 3 screws to a motor on the test flight and now its grounded till I get more screws.
Well seeing as your ordering stuff. Get some blue loctite. Or a cheaper version.
It will stop them screws vibrating loose.
Make sure to tighten all screws before everytime yo go out. Get some nylock nut for your props if not already.