First build. test fly was no success

J

Jeff1337

Member
drone instaflips hard right/forward into the ground. ive been looking all over the web for help on the issue but can not figure it out. ive checked everything. motors are wired to the proper location on kiss fc and wired up correctly to escs (kiss 24) Ive tried calibrating them though i guess with those escs you dont have to? tho one esc blue light does come on a half second or so later than the others. could this be from any soldering issues? building this drone was the first time for all of it. never done any soldering or anything like that. anyone have any insight on this instaflip issue? its as soon as i give it any throttle at all. props are on correctly as well.

i want to fly really bad!!! IMG_1634.JPG
 
Check the esc's are to the right pins.
Reset the gyro failing that reset the board, it's next to gyro reset on the first tab in cleanflight or betaflight.
 
The props maybe on right but is the motor direction right. You do not have to swap wires, this can be done in blheli.
 
Jackson said:
Did you try it with your prop nuts like in your pic?
Click to expand...
This is how they should look.
maxresdefault.jpg
 
Motor direction is correct, motor wires correct, props and nuts are on correct, fc is facing the right direction. Doesn't the kiss fc only use the kiss GUI and not beta/cleanflight?
 
Yes kiss has its own programming.
I would have thought it has a gyro reset.
I reset them after every session or a hard crash. Sometimes it can get stuck or be out. It's just like being on a surface that's perfectly level but the gyro is out so the lowest motors will kick in first to correct to level. So if the gyro is out it can cause drift, spin. Is there a setup tab in kiss GUI.
 
You must log in or register to reply here.
Back
Top