firmware question

[Judd Thompson]

how can I tell what firmware is on my quad? I'm looking at the cleanflight on line manual and I'm not sure what firmware is on my quad. there are several choices like ALIENWIIF1, ALIENWIIF3, CC3D, CJMCU, COLIBRI_RACE, LUX_RACE, MOTOLAB, ect... Any help would be greatly appreciated.

 

[Jackson]

And how can we tell what flight controller you are using?

 

[Judd Thompson]

And how can we tell what flight controller you are using?

I'm using a Spektrum DX7S transmitter and a Spektrum receiver. The ESCs are integrated into the flight control board. The quad is made by MadLabs, it's a grasshopper 250 FPV racer. The flight control board is the entire center layer of the three board layer quad. All of the components are soldered to the board. MadLabs made the board. Upon further inspection of the board the ESCs are they are by dys and they say BLHeli on them.

 

[tylorwashere]

I'm using a Spektrum DX7S transmitter and a Spektrum receiver. The ESCs are integrated into the flight control board. The quad is made by MadLabs, it's a grasshopper 250 FPV racer.

We need to know what flight controller it is, not which reciever or ESC's you are using

 

[Judd Thompson]

The board is made by MADLAB that is all that is printed on it.

 

[Jackson]

Looks like:

• Naze32 flight controller

That's too vague there are different versions and types. And it can be set up with Baseflight or Cleanflight.

Look for NAZE choices, You should call them and get all the details.

 

[Judd Thompson]

Ok, thanks for the help, I'm a little further along than I was before.