Failsafe

[EliteMist]

Hi,
I have finally ordered all of the parts to build my quadcopter (no camera equipment that will be later) and I will be flying it very close at the beginning. I know though once I get comfortable with it I will fly it much farther and will be in a much higher risk of a flyaway. I was wondering which receiver I should get with my Turnigy 9x for a good failsafe that works with my transmitter. These are two potential ones I found (basically the same I think) (--1--, --2--).

Thanks,
Trey

 

[RENOV8R]

Hi,
I have finally ordered all of the parts to build my quadcopter (no camera equipment that will be later) and I will be flying it very close at the beginning. I know though once I get comfortable with it I will fly it much farther and will be in a much higher risk of a flyaway. I was wondering which receiver I should get with my Turnigy 9x for a good failsafe that works with my transmitter. These are two potential ones I found (basically the same I think) (--1--, --2--).

Thanks,
Trey

I don't think either is compatible with your X9 but regardless, failsafe is set in your transmitter, not thr receiver.

 

[Jackson]

I don't think either is compatible with your X9 but regardless, failsafe is set in your transmitter, not thr receiver.

The Turnigy X9 can accept various modules.
http://www.banggood.com/FrSky-DJT-2...I-RX-Receiver-Compatible-For-JR-p-988647.html

FrSky DJT is compatible with JR transmitters following:
JR: 347, 388, 783, U8, PCM10, PCM10S, PCM10SX, PCM10IIS, 8103, J9303, PX, 9XII, 11XZERO
Turnigy 9X, 9XR and Flysky 9X transmitters.

And in a way the failsafe is set with the RX. There are no menu modes as you would expect.