Drone won't fly

Good day guys I need helping advice
I just completed my first FV450 project, all is connected it's powered up, the quad is responding to the remote but it will not fly.
Please help me

Thanks
 
Yeah, we need a LOT more info. That's like saying "my car won't start, do you know what's wrong" BTW welcome to the forum!
 
Thanks a million for your response the props are spinning and the quad is responding to the remote but when throttle up it flips over and will not lift.
 
Props should be spinning in this orientation
quadcopter_x_flight_dynamics_yaw_pitch_roll.jpg
 
I just made a similar mistake, didn't pay attention to the manual. Can't just assume it seems.
 
Last edited:
Take a real good look at this:

Syma_props_complete.jpg

Red is the front. Note the high side/leading edge of the props and where they are.
 
Last edited:
Hey guys
I am not sure what I am doing wrong but I have checked everything on my quad and make all the changes but the results are the same. Is there any chance this maybe cause by my Flysky I6 control.
Please assistassist.

Thanks
 
I am very sorry Jackson the flight controller Thunder QQ Super Stabilizer Flight Controller 3 Axis
and c4x HP SimonK 30A ESC Brushless Speed Controller BEC 2A for Quadcopter F450 X525
4x Angel A2212 2212 980KV Brushless Motor/3mm + 4pairs 1045 L/R prop (RED)~A1251
FlySky FS-i6 2.4G 6CH AFHDS RC Transmitter With FS-iA6 Receiver *Mode 1*
 
Back
Top