Drone motor speed fluctuates

G

gimp24

New Member
The drone I am working on is having some motor calibration issues it seems.

When I arm the drone and and very lightly push the throttle to its very minimum setting, the motors start spinning equally and then motors 2 and 3 begin ramping up speed on its own. I have calibrated the motors several times and have had no results. I've done a little messing around with PID but didnt notice any changes related to this problem.

When I use CleanFlight to test the motors using the Master Slide button, all the motors start at 1117 and stay at a constant and equal RPM, its only when I use the controller does it misbehave.

  • CC3D Storm, flashed to Betaflight to use CleanFlight.
  • Arris 12A ESC
  • Tried recalibrating several times.
  • Minimum command is below maximum throttle
  • FlySky FS-T6 controller
Here is a video to provide better troubleshooting help. Watch the 2nd and 3rd motor ramp up in speed on their own.
 
Last edited:
Have you also calibrated your ESC's?

Have you got the ground wires from all 4 ESC's connected to the CC3D. Some ESC's make your motor sact up if you just connect the signal wire
 
My motors are calibrated, but I did not see what part in the video where he calibrated his ESCs.

I also want to mention it is not my receiver, I determined that from within cleanflight.
 
thanks for the response.

I've done this at least 6 times now after nearly dissembling my drone. If I slide the master switch, the motors will stay even and appear healthy, but when I lightly push the throttle, it will keep ramping up.

Watch the video i posted. You can see its armed and I bump the throttle a little and leave it where its at... Motor 2 and 3 will start increasing RPM on its own.
 
You must log in or register to reply here.
Back
Top