Darkmax Receiver problem

[Garpee]

Cant get the receiver working on the furibee darkmax

 

[mozquito1]

What Tx & RX is it & what fcb, I can't tell from the video. Would be better with a picture of the board. Sometimes a picture speaks a thousand words & a video speaks a thousand pictures, Sometimes.

 

[mozquito1]

Sorry I only access this site through my Android phone. Sorry, can't see properly.

 

[Jackson]

Which one did you get?

This one.

BNF WITH FLYSKY AFHDS 2A RECEIVER

 

[Garpee]

Which one did you get?

This one.

did get the https://www.gearbest.com/brushless-fpv-racer/pp_765196.html afhds not the 2a one... thought it would work with my transmitter. Tried witha new reciever (the one in vid) https://www.banggood.com/Flysky-FS-...i-BUS-SBUS-Output-p-1092861.html?rmmds=search

 

[Garpee]

What Tx & RX is it & what fcb, I can't tell from the video. Would be better with a picture of the board. Sometimes a picture speaks a thousand words & a video speaks a thousand pictures, Sometimes.

 

[Garpee]

Cant get the receiver working on the furibee darkmax

https://www.gearbest.com/brushless-fpv-racer/pp_765196.html
https://www.banggood.com/Flysky-FS-...-p-1092861.html?rmmds=search&cur_warehouse=CN

 

[Jackson]

not the 2a one... thought it would work with my transmitter.

Did you go into the i6's RX setup and set AFHDS 2A to OFF?

 

[Garpee]

Did you go into the i6's RX setup and set AFHDS 2A to OFF?

yes

 

[Garpee]

You can see the same problem here.

at 6min. However this did not work for me...

 

[Garpee]

it could be mah bad soldering whos causing the problem

 

[Jackson]

I'm confused by the vid, since Betaflight directly supports IBus, why the soldering to the sat port? Can't you just connect normally to the port and just set BF to IBus.

Then look in your CLI commands and invert the port.

 

[Garpee]

I'm confused by the vid, since Betaflight directly supports IBus, why the soldering to the sat port? Can't you just connect normally to the port and just set BF to IBus.

Then look in your CLI commands and invert the port.

And how do I invert the port in my CLI commands?

 

[Garpee]

I'm confused by the vid, since Betaflight directly supports IBus, why the soldering to the sat port? Can't you just connect normally to the port and just set BF to IBus.

Then look in your CLI commands and invert the port.

and how do I do that?