Search results

I had the wrong rx selected, it was never a binding issue. Got a lot of good experience on the journey though!

So I decided to flash Betaflight onto my Naze 32 Board (FS-1A6 receiver is/was an RTF p130 I transplanted onto a 180 mm frame) flash and firmware was no problem. I used the bind plug and followed these instructions (insert bind plug quick flash turn on FS-i6 with bind plug pressed then wait for...

Oh ok. Thanks. I was looking for a tutorial on how to flash this onto the board.

I wasn't sure if it was supported. I think so but its Naze 32, but I see that some of the pros on youtube are using it

No, I am using Cleanflight, although I see that some more experienced people use Betaflight, I read so,ethereal r the Naze32 board didnt support it, so I am erring on the side of caution.

Thanks so much for this. Don't say that about your imagery. I am good with math, and I am a decently smart person. however the way you illustrated PID's in the video helped me, a noob, A LOT.

Update. I had the wrong channer on the controller tab for the switching between Angle>Horizon>Air/Acro. i have not had a chance to flt it since I made some slight changes to the P.I.D.s. I have watched so many videos, but the one I found on this forum under "Build and Tune", posted by Raymond...

So. Inspired by videos by Nick Burns and Andy RC, for my first real foray into the next level of this Hobby, I got a JJRPRO P130 battler and transplanted it onto a 180mm frame, with 4" tri blades. WHAT A DIFFERENCE. I took it out for a proper maiden flight and its awesome. I think I set up the...

So. Inspired by videos by Nick Burns and Andy RC, for my first real foray into the next level of this Hobby, I got a JJRPRO P130 battler and transplanted it onto a 180mm frame, with 4" tri blades. WHAT A DIFFERENCE. Almost too much. It is almost too responsive? I tested it and it almost...

Found it, it was a bad solder joint... now to deal with a sticky throttle

I transplanted over my P130 Battler guts to a 180mm frame. I had to drill on the bottom to get my M2's in as the frame is a little thicker than the original. It powers up and 3 of 4 motors spin. The left rear moter WANTS to spin it moves but not much.. It just kind of jiggles there. I...

Yea it will fit. In the video it is linked from ANDYRC uses the same frame I have, its the frame for the JJPRO P130 Battler. I am stripping mine down and tranferring its gear to a bigger frame so it can swing 4" props

In the meantime would you mind linking the components you use on your builds of this size? https://www.gearbest.com/multi-rotor-parts/pp_604980.html?lkid=10714739

I was looking at a tower set up with 4in1 @ 30amp, so in theory it could support up to 4s (I think 3s will be plenty with the motors I am going to use.

Hello all! I have a spare 130mm frame and I want to take the plunge! I own a FLYSKY Tx and I am going to use 1306 4000kv motors (not sure which ones the EMAX are nice but 15$ each is a little high for me) I need this to be on a budget (my wife is awesome but she has her limits) So I am looking...

Oh sorry they are 8.5x20mm brushed motors, not the brushless kind.

I tried to ask this on another forum and I got crickets, it might be a dumb question. Will a the Blade Inductrix (tiny whoop) board run 8.5mm motors? I have one and I have a Parrot mambo frame and motors...