Search results

HAH! I came to work and used a PC with "STM8 Flash loader demonstrator". I was able to flash the thing and give it the proper drivers so I could flash Betaflight. One board was bad too I think. Albert Kim has a video on how to unbrick so maybe...

Yea, I have 2 of them, both have the same problem, guessing we are dealing with a driver problem here

Cleanflight is a no go, and the boards are fresh and uninstalled, flashing first

MacBook pro so I have some limitations. I can try that baud rate. I have the latest CP210 (maybe a reboot after install might help as I did reinstall them.

STM32 Communication failed, wrong response, expected: 121 (0x79) received: 31 (0x1f)

getting this in BF

Got two of these: https://www.gearbest.com/flight-controller/pp_638475.html F3 ACRO 6DOF Flight Controllers. One has its boot pins bridged one does not. Can't seem to flash BF or even Cleanflight. It says in CF it needs an update but when I go to choose the version I pick SPRACINGF3 and the...

Figured it out by watching reviews, the said wire went somewhere else. Should have made a legend on paper.

I don't know about my luck lately... I was working on a problem with the VTX, which I am replacing, and when it was reassembled this began to happen, a long constant beep that does not end. It seems to be when I plug in ONE wire, without it no beep. Not sure what the log unending tone means...

Update, it seems that the props went off too, and only 2 were spinning. Banggood is sending a new ESC. Hope this gets it going again.

Turns out that this is a known issue. Ultimately I wish I had known this I would not have invested in it, frankly: https://www.rcgroups.com/forums/showthread.php?2927885-Can-t-stop-drift-issue-with-Lizard95 It is exactly as they describe here. I think the heading should be "Beware buying the...

Oh no problems there, I already arrived looong before I started FPV...

OK. SO. I got the FLYSKY version, bound it and got it set up for angle/horizon/airmode. All I use angle mode for is taking off and getting used to the craft, WHICH I HAVEN'T been able to do! It does not take off like my other quads, as in UP>(very little manipulation) HOVER. I have been TRYING...

Well the Rx wasn't included in the auction, so getting anything was a bonus. This quad flies really nicely. As it stands the Rx is fine all pins intact for PPM, which is what matters. I am probably going to order 3 or 4 of those Rx soon. Thanks for the heads up...

Well not HORRIBLE lol, I know "props off" but I wanted it to catch it lol.

yea me either tbh. I think it should be fine, I will let y'all know how it goes, the sad thing is I have barely even flown this model! Just got it today through eBay (the seller said it was too advanced for them, they sent me the model another FSi6 Tx, and a damaged receiver which is fine for...

So I exposed this on the broken off end. If I strip off the casing on the inner wire here and do the same with the other piece would the solder joint be a problem for the signal?

The black piece on the right fits over the exposed part, you can see the fissure where it cracked (I can fix that back with a bit more heatshrink.

I would agree, except the tip was like this picture the piece has the specified length out the top. Also it is the interior wire that matters so I wasn't certain if soldering it would matter since the end is already made to have the right exposure...

Got my new unit all set up and went to test, but didn't finish securing antennas. So of course when i landed it flipped an chopped one off. Can I splice it? Or do I have to expose 31 mm like explained in this video: