Naze32 setup: tx/rx and motors

D

Dallen

UtahRCGuy
Hey guys,
I am switching out my fc from a kk2.1.5 to a naze 32. I successfully flashed the latest firmware. I have it all plugged in correctly but just a few things don't work while I am trying to set it up.

The screen that shows the transmitter inputs does nothing when i move the sticks. I am wondering if I have an incompatible receiver (HK6s)

When I move the sliders to power up the motors, nothing happens. I have no idea what to do.

I also feel like my board should be ready to arm and spin up the motors by now, but nothing i try seems to work...
Hopefully this is enough info, thanks in advance.

-Dallen
 
Dallen said:
Yes. No success
Click to expand...

No offense, but when you say you have it plugged in correctly, are sure that's the case? I'm just saying that If it's plugged in correctly then it would most likely work, wouldn't it? otherwise you have something set wrong in the setup and configuration or you have a component problem.

Is your Receiver powered up?
Is your battery plugged in? You have to have the battery plugged in to power both the RX and run the motors.
 
Altsickeness said:
No offense, but when you say you have it plugged in correctly, are sure that's the case? I'm just saying that If it's plugged in correctly then it would most likely work, wouldn't it? otherwise you have something set wrong in the setup and configuration or you have a component problem.

Is your Receiver powered up?
Is your battery plugged in? You have to have the battery plugged in to power both the RX and run the motors.
Click to expand...

yes, the receiver is powered up and connected to the transmitter. yes that battery is plugged in. neither components are fried, so i feel pretty good.
 
ringolong said:
Have you went through these?

Click to expand...
Hello, I have an Eachine 250 and have had it for about 6 months, I recently purchased the Eachine Assassin 280 racer, my problem is...Cleanflight does not see my FC Naze 32 and I have no idea what to put in the port box in cleanflight?? I am pretty sure this is the problem? But when I click connect it keeps saying failed to connect, and I haven't put anything in the port box so I figure that's the problem and I've watched the video you posted by painless 360 and get it, but he never mentions what to put in the port box in cleanflight. Also the configure wire that goes in the serial I guess port of the board that your suppose to have plugged in when configuring and I do and tried it both directions, for, one video I watched he puts it in upside down looks to me like? In the video the wire at the very end of the plug is on the left end of the connection and at the right end it's in the second to last hole. Well by the looks of the plug it goes in the other way for the little notches in the plug holder and the protruding rails if I may call them that on the plug look like they line up the opposite way than that, and tried both ways HELP PEASE any help to configure this thing the ARF version with the flysky i6 radio and the i6AB or whatever version not the regular i6A but the one with the B on it also. I drastically need help in getting cleanflight to see my FC and utilize the app so that I may configure my transmitter and copter and fly!!! The receiver is bound it did that just fine as I did the new radio to the 250 racer also. Any help would greatly be apreciated!!?? Thanks, Turbo930.
 
You must log in or register to reply here.
Back
Top