First Build Suggestions

R

RejectedWolf

New Member
Hey guys, I have been flying a pre made quad for a while and I have been looking into building my own 250 quad. Here is the build list so far:

DX5e DSMX 5-Channel Transmitter with AR610 Receiver
Fat Shark Teleporter V3 Video Goggles
Lumenier Mini 20A ESC w/ SimonK AutoShot, 5V/1A BEC (2-4s)
QAV250 Angled Motor Mount Extensions

QAV250 Mini FPV Quadcopter Carbon Fiber Frame
FXC2206-11 2350kv Motors
Acro Naze32 Flight Controller
Lumenier 1300mAh 4s 60c Lipo Battery

What do you guys think? Have I done something incorrectly? Are there any things i could upgrade for more performance? I am pretty set on the FPV kit and I already have the Batteries, Transmitter and Receiver.


 
Don't get the teleporters, I have known people to throw them away out of the box haha. Their picture is the size of a postage stamp (if that) and you can't make out much of what is in front of you. If you want fatsharks then I'd get at least the Domv2.
If those are out of your budget then take a look at this thread, the quality is great, ~equivalent to the domv2, but bulkier.
 
Jackson, I managed to get the Transmitter and reciever from Horizon hobby for about $80, so thats not a problem.

GJH105775, I am not on too much of a budget. the set up I am looking at is sitting at about a grand. I dont want to be paying an arm and a leg for my FPV set up. More just looking for a good bang for your buck set up so I can figure out what i like and go from there.

Do any of you guys see any power issues? I have not seen too many people running 4s at 60c and i picked 20A ESC so that I dont fry the 12A ones? Am I going overboard with any of this?
 
The well it would take very little time to hook a rx up to the quantum v2 googles and the camera set is plug and play.
 
You must log in or register to reply here.
Back
Top