Turnigy Tallon v2

T

Tase

Member
Frame- Turnigy Tallon v2
Flight controller- Naza m lite with GPS
ESC- Turnigy multistar 40a slim
Motor- Turnigy multistar 4010-580kv
Prop- DJI 15X7.5
Battery- Turnigy multistar 4s 10000
FPV- custom 800tvl Sony camera with 32 channel rx/tx with pitch control
cI7o3a8

082hcK2
 
HI mate the talon frame is nice I have it as you can see in the pic mine is now a 700mm , but there is no room on this frame for any thing the room between top and bottom plates if tiny I had to make up a plate to mount under to hold the receiver and power board , I dont know if your have the room to mount the GPS or camera, here is a photo of how tight space is IMG_1022.JPG
 
Mines actually completed with more than 200 hrs flight time! I purchased 4 frame kits so I have a lot of extra parts. I used multiple plates and spacers to sandwich all my electronics! Those pics are it's final configuration.
iYP0Ql9
2PJ4Gsl
9rhNH1R
 
Hi mate I was going to do the Was going to do the same but no stock so used a plate off the x525
 
Yes I had an old X525 frame so used the bottom plate to mount receiver and power board , you could always buy a sheet of carbon fibre and make up a plate
 
its on a KK2.1.5 hard case , I am thinking of stripping it down and build the talon tri-copter
 
Large quads can be light but cost more the lighter they are , 250 racer is so fast most crash thats why they have bags of props
 
They always end up heavy though once you start adding 2 video systems two cameras big gimbal all the fun stuff!
 
Not really! I'm just good with hobby parts. My next setup however is going to have an HD transmitter so everything looks nice.
 
You must log in or register to reply here.
Back
Top